Contact us
Processing method
How to maintain & clean PVDF coating
Frequently Asked Questions
Knowledge of aluminium composite panel
 
 

Processing Method
The fabrication of SAKURA Aluminium Composite Panel can be done by extremely simple woodworking tools or metal tools, such as shearing, sawing, milling, punching, pressing, folding, bending to arc and inverse arc, small radius round angle, inner and outer turning angle, right angle and etc.

 

Cutting
It can be cut into all kinds of shape by using water jet, contour milling machine, forming saw and curve saw.

   

Drilling
Panel can be drilled by twist drill, which is usually used for drilling aluminum and plastic.

   

Shearing
The shearing can be done by shearing machine. When shearing, please make sure there is a gasket under the blanking tools.

   

Riveting
The riveting can be done by simple tools, rivet or blind rivet. When using it for outside, please take the heat expanding into your consideration.

   

Hole Punching
General eyelet machine can punch holes on panels with any thickness. When cutting, please use steady installation tools and make sure there is a narrowest gap.

   

Cut Thread
Using general eguttulate wood, metal sheet and metal screw. When using it for outside, please take the heat expanding into your consideration.

   

Bending
Bending can be done by folding table or brake press. The bend inside diameter is about 10 times thicker than the panel thickness.

   

Welding
The panel can apply to heat air welding. Use heat air weld facility to heat and weld plastic core and plastic welding rod.

   
   
 
Copyright2007-2010,All rights reserved,Sakura